Convoy Dice

@LebaneseWarlord said in Need advice for custom dice DIY:

I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.

I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.

For the marking, I was thinking about using a rotary tool to carve a little dot.

The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.

Wash the dice to remove any grease that could be on the surface Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick Wash the dice again the remove the dust from the paint removal Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer Apply a few thin layer of the color I want on the dice Paint a white dot in the carving I made earlier with a fine brush Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint

Any correction or suggestion would be very welcome!

Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them

I could help with financing?

Dice would have either land or naval with a separate category of Air because that branch overlaps both

Symbols for land: ( green) 6 dice in set
Infantry x 1
Armour x1
Mech x1
Artillery x2
Blank x1

Symbols for Naval: ( blue) 6 dice in set

Battleship x1
Cruiser x1
Destroyer x1
Submarine x2
Blank x1

Symbols for Air: (white) 6 dice in set

Fighter x2
Fighter-Bomber x2
Strategic Bomber x 2

Dice roll and tumble and land where they may, to think too much about is crazy… roll this one, roll that one… “if I only rolled it with this side up, would be different outcome”… it’s too much… granted if every roll was a six, be weird, but that don’t happen, least in my games… I say just “roll” with it… you win some, you lose some.

@Mr_Tricorder:

Have tried them out yet? If so, how big of a difference do they make?

Yes.
It’s definitely faster.
And it removes irritating conversations like:
“3! Hit!”
“Wait! Didn’t you announce rolling for your destroyer?”
“Nope. I wanted the cruiser.”
“Hmm”

@SS:

Siredblood has a you tube video of drilling colored dice

I got my inspiration from that one and added the extra holes for 2,3 and 4.

I just don’t think you folks understand what im looking at. The picture is forthcoming because i don’t actually own it, but i game with it for like 25 years.

Thanks you for the reply! E-mail sent to Chessex - looking forward to getting these.

thanks IWNGU :)

@Gargantua:

Has anyone thought making the board from Acrylic??

Or is it too prone to breakage?

I had considered etching the country and seazone borders into the bottom of the acrylic topper on our topograhical board.  Would have been very cool, but too difficult at the time (skill level required was beyond me at the time).

I don’t think it would have been particularly prone to breakage.  Acrylic sheets are pretty resiliant.  SCRATCHING on the other hand would be a major issue to deal with.