"Tall Paul's" A&A INFRASTRUCTURE units detailed and painted by "WARMACHINE Team"

https://www.facebook.com/pg/Landing-Vehicle-Tracked-LVT4-2017381051873202/photos/?tab=album&album_id=2201403350137637

I have seen lots of people here use acrylics and I have on occasion. Most of my paints are enamels though. I find that is stays wet longer (which is a good thing) and doesn’t clump up nearly as much on your brush. I also use enamels in my airbrush. I find that enamels are actually much easier to clean than acrylics. While acrylics are water soluble, they don’t just dissolve, especially if already dry. It involves a great deal of scrubbing and scraping. With enamels, all you need is some mineral spirits cleaner and it takes the paint right off with very little effort. Cleaning acrylic paint out of my airbrush was hell the first time I did it… never using acrylics in there again. In terms of the finish, I can only assume that enamels hold up better to bumps and scrapes than acrylic paint does.

Someone once asked if enamels, by default, have a glossy finish to them. They do not, as long as you are using flat enamels, which seem to be the standard. I use flats and they have an excellent, non-shiny finish. I feel like enamel colors are a little deeper too, on the whole, but I suppose it depends on the brand of acrylic you use. Vallejo seems to be a popular choice for acrylics. I use predominantly Model Masters (Testors) enamels. In general, I would just said to find a brand you like to work with and produces the results you like. Don’t buy super cheap paint… you will get the results you pay for.

Good luck!

Nice work - Dare I ask how many hours you put into it? For interest’s sake.

Man, those are sweet too! Very nice! Don’t won’t to mess with the black shirts, LOL. :-D

The next group of infantry, will be, DESERT LIGHT INFANTYRY.

Until next time.

Cheers!

John

Wicked!!!

It does fit, u place the two pices on top of eachother (they are only 40 mm high, the man board is 50 mm outside = 42 mm inside). The space is 600x800x84 when folded, the two pices on top of eachother are 500x600x80. That leaves a 300x600x80 space and my plan there is to make box of wood or paper to store units, dices etc!  :-D

@sgtwiltan:

It’s really too bad you didn’t make the side piece so that it would fit into the inner portion of the main board where the map is.
You could even make a simple cover to keep the pieces inside from falling out all over the place. It’s a great idea you have there though.

this first pic is what i had been using, i manually printed things out in one page sections via “print selection” command and pieced them all together, and laminated them with clear packing tape. Ultimately it proved to be a little larger than the default gameboard like I wanted, but still sloppy looking and with some bumps here and there which complicated unit placement due to tipping or sliding:

it was larger enough than the default board that things in europe didn’t seem so crowded anymore, but shoddy looking still, and that can wear on the nerves.

So I finally said enough is enough, and took the map pdf file on a jump drive down to minuteman press in London Kentucky and had them blow it up and laminate it….it costed $118 IPCs U.S. Dollars.

Its 2 foot by 3 foot, and gives us plenty of room for stacks. I got tired of kenny’s fat fingers knocking over my german stacks and scattering them across europe…he says my money was wasted because “those damn germans were going across europe anyway I just helped you out is all”.

but here it is: