Modifying FMG's Italian Battleship

Good detail on FMG’s pieces.  Glad I bought them.

I am painting them avocado green to give these pieces a more distinctive colour than the Russian pieces.  That being the case, I thought I could fix something that was nagging me …

For example, the B turret on FMG’s Italian battleship sits at the same level as the A turret.  This is incorrect.

You can see in the attached pictures the B turret behind A.  B should be raised above A.

A closer look at the forward turrets.  Again, the B turret should be raised above the A turret.

What I did to fix this was I shaved the raised barrels of the B turret off.  I then used sheet styrene and cut out a square shape in the same size as the turrets on FMG’s ship.

I glued this on top of the B turret.  I then cut out 3 barrels and glued then on top of the A turret…

I didn’t take pictures of this,which is too bad, but here is the final result after priming and painting.

Here is the unmodieifed ship, and teh modified one beside each other for comparison.

Cheers

The battleship I modified was FMG’s.

Unless you mean other pieces?  I used Table Tactics’ half track, and Avalon Hill’s infantry.  All other pieces I used were FMG’s.  I didn’t use FMG’s trucks, armoured cars or infantry.

@Tall:

Jim010,

Good Job!  And on such a small size as well.  Well done.

“Tall Paul”

Thanks.  Wasn’t hard to do, though.  I still have a couple Italian BBs I will do, so later on I’ll post a how to.

CHeers

OK, here we go:

First, here’s a shot of teh FMG BB again before modification.

Use an exacto knife to trim off the B turret barrels so that you have a level plane from the top of A turret to the top of B turret.

Here the BB is showing how it is to be trimmed.

You’ll need sheet styrene.  Cut out some pieces and glue them on top ofeach other in a stack equal to the height of the FMG BB turret.

Then trim the piece into the square shape of the turret.

Glue the new turret on top of the BB’s B turret.

Next, you’ll need to make the barrels.  I used styrene strips .022 x .033 .

Cut 3 equal length strips the same length as the BB’s barrels.

Glue them in place using cyanoacrylate glue.

All 3 barrels in place:

And then paint whatever colour you wish.  I primed the ship first, and then used an acryllic avocado green for the ship, as I did all the Italian pieces I have.