John Brown's Painted Axis and Allies Pieces

Here’s another pic in dimmer light, which is a better comparison to the before picture above.

The silver pops nicely. Before, in the same lighting situation, I couldn’t see most of the border lines at all.

I used the Edding 5300 silver acrylic paint marker with a 1-2 mm tip
The silver seems to really catch what little light there is in the room.

As the paint the marker ran low of paint it was harder and harder to control, so I reccomend just stopping and using a fresh paint marker if this happens. A few of the last lines I did are fatter than I would like because of this.
But the overal result is a huge improvement.

IMG_20230304_154631.jpg

@Trenacker:

I look forward to buying some cruisers and battleships from you in the next month or so. What is the appropriate scale to match up with OOB pieces?

On the left-side of my shop homepage there is a list of categories. Anything in the “Axis & Allies” categories is sized to exactly match the OOB pieces. Avoid the 1/1800, 1/2400, and 1/4800 scales. Also all of my models should have their dimensions listed in their descriptions, so you can verify the size if you’re interested.

I think they would stack well in the box as long as you remove the cardboard boxes.

If you are really looking for a good finish on all your HBG pieces, you could buy a couple small cans of differing lacquers and test each one. $20 should get almost 3 cans worth. It may be a waste to some degree, but at least you can know for sure which one works best.

I have a flat Testors lacquer/sealant spray that I used on Tall Paul’s finished pieces. Granted, these were painted first, so the effect may be thrown off. However, I will say that I did not observe any level of gloss on the HBG or OOB pieces after I applied it. It was quite flat as advertised. FWIW.

Sounds great!

These are amazing, keep up the great work.

Fellow A&A Gamers,

––This thread will eventually contain ALL of the Anzac units that I’ve had detailed & painted by the “WARMACHINE Team”.

––So far the list includes:

ANZAC

ANZAC ARMY
Anzac Infantry
––Anzac (Infantry, Rifle)…(Starting at message #1)
Anzac Armored Vehicles
––M-3 Stuart “Honey” (Tank, Light)…Outback Camo scheme…(Starting at message # )

–-----------------------------------------------------------------------------

Everyone.

----Here are the Anzac Rifle Infantry that Chad Coffman, a.k.a. “Allworkandnoclay”, painted for me. All 20 of the Australian Infantry, nick-named “Diggers”, after their WWI fight at Galipoli, are shown here in a group portrait just after completion by Chad. Note the intricate Anzac ensign he painted on their bases. This guys painting talent is simply awesome! So just sit back, put another shrimp on the barbie, and enjoy, mate.

“Tall Paul”
anzac_inf2b.jpg